Parts
Jefftron Switch Brake With Wiring Micro Switch Replacement
£32.95
Unavailable
Jefftron
SHARE THIS PRODUCT:
Jefftron Switch brake with wiring Micro switch replacement
This is a professionally made MOSFET with active braking, which can be disabled by removing the red jumper.
This device is designed to replace the microswitch in the specific gearbox V2. There is no modification needed.
In semi-fire mode the piston isn't partially stretched, the spring is fully released, parts in mechbox aren't under strain and the nozzle locks the hop-up chamber in greater part (depends on ROF).
The Jefftron Active break solves multiple shots in semi mode with weapons with very high rate of fire (ROF).
This device increases your guns rate of fire and your battery will last longer than it would with basic wiring.
Key Features:
- Easy installation inside the gearbox version 2, which replace microswitch
- Presoldered wires allow faster and easier installation into the gun, it is long enough for all kind of weapons. Simply cut wires to the required length and attach connectors (included in package)
- On the devices are presoldered high quality 2 black wires 1,5 qmm (AWG16) with with thin and hard MPPE insulation, length 300 mm to the motor and 700 mm to the battery. The blue wire 0.34 qmm (AWG24) with a length 1000 mm is used for connection anywhere on the red cable
- In package is included 1000 mm red wire 1,5qmm (AWG16) with with thin and hard MPPE insulation
- Coated with lacquer, it protects the device against water
- If you want to use your own wires, choose variant without wiring
- Disable active braking by unplugging red jumper, when you gun has Rate of fire under 20bb/s, otherwise, it could lock up trigger on SEMI due to too low gear speed.
- Motor will be under less stress without active braking.
- Designed for spring up to M160 (equivalent for current 75A single shot fire or 25A burst fire for max. 30s)
- Specified for common batteries up to 17V (Ni-xx 8.4 - 12V, lipol 7.4 - 14.8V)
- Active braking uses excess energy from the motor to stop it. The braking effect is the most powerful with high torque motor
- No current consumption in the idle mode
PACKING:
- Device with wiring
- DeanT connector male
- 30A mini fuse
- 4 x faston female 2,8mm
- 6 x black heat shrink tube 3,2mm - length 20mm
- 3 x black heat shrink tube 4,8mm - length 20mm
- Installation manual in English